Restoration of my families grocery getter

[Wonderwagon]

Front end is "on". Need to find the blower motor and test, the antenna base will need to also be installed. Paint work seems to be okay no solvent pops at this time. Head light baffles, hood latch and support next. Extra set of hands was helpful and good to see an old friend too.

 

[Polara_500_Jr]

What is this piece? Where does it belong? There was one under the 65 Polara I have been working on and I can't figure where it was from. (I did not disassemble it, only trying to reassemble)

 

[Wonderwagon]

That is the radiator/ core support shim, goes between the frame and support.

 

[Wonderwagon]

So, nicely painted fenders, out of clean new moving blankets to set them on. Do you set them on the concrete, hang them up? Or grab some house hold rugs, a yoga mat and a blanket? I opted for choice three and got the "LOOK". Fortunately my buddy had the save and put the paper on top of the padding collection just before some rattle can spray work on the inside of the fenders.

 

[Wonderwagon]

Monday, when we mounted the fender extensions, we found the drivers side missing its cast on studs for the stamped nuts. Must have sheared off when the NOS fenders were installed. My Dad at some point took them to work on a midnight shift. He filed them flat and drilled and tapped them to accept a 6-32 screw, it captured the stamp nut and put it into compression to hold the extension tight. Ways a nice reminder of him.
Today's progress, trial fitted the headlight baffles and the hood latch and support. It's not huge but, an empty bag for the fender extensions and some toe tags being retired. Now to find the fender braces that are painted, hmm where did they get squirreled away?

 

[Wonderwagon]

Started the under dash trim piece repair, that should not have happened. Any how, started with relief cuts on the center rib to allow a gusset plate to be installed. Once the relief cuts were made the center section was filed down to allow the Polyester plastic piece to fit flush avoiding the side screw holes. Paper pattern was made and traced out on the plastic and cut out on the scroll saw. Filed to fit. Once a good fit was achieved, relief holes were drilled and counter sunk to allow the epoxy 3M DP 100Plus to ooze through and spead out like a rivet is the intent.

The side mounting screw holes were busted out along with the tabs that hold the trim piece up. These will be replaced with new plastic as well. Once the plastic is superglue and hopfully reinforced, plan on the new material being slightly recessed and brought to the correct height with a combination of filling crumbs and super glue.

 

[Wonderwagon]

Some snacking today, fender braces, battery tray test fitted and filler pieces below the tail lights.

Battery tray was dusted off after the pic.

Fastners on the extensions will eventually get swapped for painted ones

 

[FURYGT]

I trust that you know that the battery tray should be body color.

 

[Wonderwagon]

I trust that you know that the battery tray should be body color.

Hmm, no I didn't, the brace should be black?

 

[FURYGT]

Hmm, no I didn't, the brace should be black?

Yes, the brace is black.