Biggredd2069
Active Member
I'm debating to buy a firm feel stage 2 steering gear box and new Pittman arm soon. I'm a little scared to do the job myself. I've done quite a bit of work on my car but wondering if there are any tips or tricks that would be helpful to know before I start on it I can plan for? Think I'll Need to reuse my pressure fittings. But other than new fluid anything I should have on hand? Any special tools? Think there might be one needed to separate the steering shaft? I've been doing a lot of research, just getting close to being a reality now and want to make sure I don't mess anything up too bad. There is barely any tutorials for anything for this car other than fsm's.
I'll probably be doing a new gasket and fluid on my rear diff too if any advice for that.
I'll probably be doing a new gasket and fluid on my rear diff too if any advice for that.