Hurst 300 Stripe Kits - Performance Car Graphics

[Mike Mancini]

Let me get some pricing together on a small run of each, say quantities of 25 and 50 and we can go from there.

 

[Mike Mancini]

Hi Guys,

OK so to do a small silkscreen run of the above pictured tire pressure and emissions decals would price them at $29.00 each to make it feasible. I would have to sell about 45 of them to break even. Let me know if this is of interest and if so, I could move ahead.

Thanks
Mike

 

[Samplingman]

Hi Guys,

OK so to do a small silkscreen run of the above pictured tire pressure and emissions decals would price them at $29.00 each to make it feasible. I would have to sell about 45 of them to break even. Let me know if this is of interest and if so, I could move ahead.

Thanks
Mike

I’ll go for a set.

 

[AL_Brad]

Info on 300 side stripes Mike. There are four separate pieces -

Stripe thickness:
T - 2/32
C - 4/32
L - 6/32
Gap - 10/32 (x2)
Total thickness - 1"

1/4 Length angled taper f/r:
T - 18.25
C - 17 5/8
L - 16.5

2/4 Length angled taper f (would need L&R):
T - 20
C - 19.75
L - 19.25

3/4 Length (door):
50" square at both ends

4/4 Length (rear qtr):
95" square at both ends

Any other 300 owners interested?

 

[Big_John]

Hi Guys,

OK so to do a small silkscreen run of the above pictured tire pressure and emissions decals would price them at $29.00 each to make it feasible. I would have to sell about 45 of them to break even. Let me know if this is of interest and if so, I could move ahead.

Thanks
Mike

I'll go for a set also.

It may be best to start another thread about this. Not everyone will see this thread.

 

[noah300g]

Hi Guys,

I took over Performance Car Graphics a couple years ago and have been working on getting all products back available and one of them I am trying to get together now is the Hurst 300 sets. These are a bit complicated and I would like to ask this crowd if they purchased a set from David before for their car and if so, do they happen to have the detailed instruction sheet that he had put together? I can't seem to locate the instruction file in the stuff I got from PCG. If anyone has one, if they would be gracious enough to email me a copy to cargraphix@aol.com. I would like to get these back to market as many people have been asking.

Thanks
Mike Mancini

I have an NOS Hurst stripe kit (no instructions) that has everything but the wheel stripes. Will you be making the wheel stripes available separately?
Thanks,