I'm not a metal man but...

Let the fun begin ... sanding (for a change..) and buffing . Sanding down to #2000 (1000-1500-2000) and then buffing.
Front fender done for example, still hologram remover need to do but looks quite ok already.
Regards, Mika

IMG20250208200636.jpg


IMG20250208194326.jpg


IMG20250215190302.jpg


IMG20250215192031.jpg


IMG20250223193012.jpg


IMG20250223193225.jpg


IMG20250223193141.jpg


IMG20250223193040.jpg
 
Let the fun begin ... sanding (for a change..) and buffing . Sanding down to #2000 (1000-1500-2000) and then buffing.
Front fender done for example, still hologram remover need to do but looks quite ok already.
Regards, Mika

View attachment 707477

View attachment 707478

View attachment 707479

View attachment 707480

View attachment 707481

View attachment 707482

View attachment 707483

View attachment 707484
Sanding is soo much work and kind of nerv wrecking, at least for me, because of the fear to sand through the clearcoat and start all over...
But the outcome is impressive! So shiny!

Great work!
 
finally all parts are sanded and polished. Not so bad..
Last picture: right side is rear fender and left side stuff in the garage..
Short video here:
.. somehow video quality is low, however it's fine was fine before releasing?? Hope you guys get the idea anyways..

IMG20250722172146.jpg


IMG20250722145709.jpg


IMG20250722145600.jpg


IMG20250722152440.jpg


IMG20250722163955.jpg


IMG20250721154829.jpg


IMG20250328201406.jpg
 
Last edited:
Back
Top