mopar Joe 65
Member
Could anyone tell me how my trunk seal goes on ? I scraped off my old rotten seal and don,t remember how it was put on. This is a 65 fury 3 and the seal i got is supposed to fit ? I will enclose a picture of trunk and seal.
Trunk seal
- Thread starter mopar Joe 65
- Start date
I can't tell by the photo if you have the correct seal or not. The flat part of the seal gets glued down in the channel on the rear and goes on top of the lip up the sides and around the trunk opening behind the rear window. The seam should be at the middle of the rear. The attached might help even though it is an example of don't trust something that is supposed to fit car without measuring it.
This photo may help.
This photo may help.
mr. fix it
Old Man with a Hat
here's my 66 Polara if this helps.
Flat edge to the inside and the lip on the outside towards the quarters' panel
Flat edge to the inside and the lip on the outside towards the quarters' panel
I would think the 68 is close. Here’s what I did.
68 Polara restore back on
68 Polara restore back on
Here is how mine was positioned while the glue dried.
mopar Joe 65
Member
Thanks guys , it was the right seal and i got it installed. Thanks alot for the help.
Tell us about the spare tire cover.
On my web page scroll almost to the end to find "My Christmas present from Paul" Couldn't have any "unfinished" spots. Since those pictures were taken, Paul added on the driver's side panel, three spray bottle holders for detailing cleaners and a towel rack for a selection of microfiber cleaning cloths. The panels really make the trunk pop!
Similar threads
